Snap-On EEWH331A Manual página 12

M
R
12
P2
S
2.0-7
1/25"
(1mm)
2.0-8
Installing and Adjusting the original tire
changer mount dismount head
See Figure 2.0-7
18) Fix the mount dismount head previously removed from
the tire changer onto the second snap connection (P2)
supplied with the kit. Repeat the installation operations
in points 8 to 11 of these instructions.
19) Adjust as already described in points 14 and 15.
20) Tighten one of the two adjuster screws until the inside
of the claw of the mount dismount head is about 1/25" (1
mm) from the edge of the rim, and at the same time, the
edge of the mount dismount head is fl ush with the edge of
the rim on the opposite side of the mount dismount head
in the point shown in the diagram (Y Fig. 2.0-8).
21) Complete the adjustment by proceeding as indicated
in point 17.
22) Remove the rim from the turntable.
The kit is now ready for use.
You can use the standard mount dismount head for
conventional rims or, if you need to handle rims with a
diameter greater than the tire changer's rated capacity,
rapidly substitute it with the mount dismount head with
the +4 inch extension.
The off set mount dismount head is also useful by off ering
additional tire clearance when removing and installing the
bottom bead of the tire.
Mount dismount head change-over is extremely fast,
allowing you to work on rims with a diameter up to four
inches larger than the maximum permitted on your tire
changer.
Snap-on EEWH331A
EN