EN
4.1-9
4.1-10
4.1-11
4.1-12
I. Repeat the process for removing the lower bead. With
left hand, lift the bead in position diametrically opposite
the tool to keep it in the drop center (Fig. 4.1-9). Tilt back
the tower assembly and remove the tire.
4.1.1 Use the bead presser as a demounting
help device.
A. Press down the sidewall of the tire to ease the
introduction of the tire bar (Fig. 4.1-10).
B. Position the lower disk next to the lower rim edge. Hold
firmly the handle, and at the same time rotate the turntable
(Fig. 4.1-11 / 4.1-12). This operation allows loosening the
bead if this is stuck and helps lifting the tire.
NOTE: A certain eff ort on the handle of the lower disk in
radial direction is normal to counter-balance
the action of the turntable that pushes the
disk off the center when rotating.
THE LOWER DISK DEVICE CANNOT BE LOCKED
BECAUSE OF SAFETY REASONS.
Snap-on EEWH331A
17