Parkside PRM 1800 C3 Instrucciones De Utilización Y De Seguridad página 31

● Scope of delivery
Check immediately after unpacking that the parts are
complete and that the product is in proper condition.
1 electric lawnmower with handlebars and device cable
1 cuttings collection bag 7
2 screws with wing nuts 5
2 cable clamps 17
1 cuttings collection bag handle 18
1 user manual
● Parts description
Start button
1
Handlebars
2
Safety switch
3
Pull relief
4
Screw with wing nut
5
Bottom handlebars
6
Cuttings collection bag
7
Discharge flap
8
Connector
9
Wing nut
10
Handlebar mount
11
Wheel
12
Cutting height adjustment
13
Motor unit
14
Carry handle
15
Connection cable
16
Cable clamp
17
Cuttings collection bag handle
18
Fill level indicator
19
Socket
20
● Technical data
Rated voltage/
frequency: 230–240 V~ / 50 Hz
Rated power: 1 800 W
Protection class: II
IP rating: IPX4
Idle speed (motor): 19,000 rpm
Idle speed (blades): 3,500 rpm
Weight (net): approx. 14.0 kg
Dimensions
(H×L×W): approx. 1440×1030×490 mm
Working width: 440 mm
Blade Ø: 440 mm
Item number: SMV1491215
Cutting height
adjustment: 20–70 mm/7 levels
Volume of
cuttings collection bag: approx. 55 l
Guaranteed sound
power level L : 96 dB(A)
wA
Sound power level L : 93.4 dB(A)
wA
Variance K : 2.09 dB(A)
wA
Sound pressure level
L : 83.4 dB(A)
pA
Variance K : 3 dB(A)
pA
Vibration
emissions value: ≤2.5 m/s²
Variance K: 1.5 m/s²
Noise and vibration values have been determined as per
EN 62841-1:2015/A11:2022 + EN IEC
62841-4-3:2021+A11:2021.
The stated overall vibration value has been measured
according to a standardised test method and may be
used to compare one device to another device. The
stated overall vibration value can also be used for a
temporary assessment of the vibration load.
Warning!
The vibration emission value can differ from the stated
values during actual use of the device. This depends on
the way the device is actually used.
It is necessary to establish safety measures that protect
the operator based on an estimate of the exposure
during actual conditions of use (taking into account all
parts of the operating cycle, such as periods when the
device is switched off and periods when it is switched on
but running without load).
Try to keep the exposure to vibrations and noise as low
as possible. Examples of measures to reduce the expo­
sure:
- Wearing vibration-damping gloves and hearing
protection while using the device
- Limiting the working time
- Using accessories in good condition
- Regular maintenance and cleaning of the device
- Switching off the device while not in use
- Preventing an overload of the device
Introduction
GB/IE/NI/CY/MT 31