User; Programming By Keypad; Remote Programming - Bentel Security BTEL-GT Manual De Instalación Y Usuario

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

NOTE - The BTEL-GT is guaranteed to function only if the device has been installed and
programmed by qualified personnel.
The User menu allows you to use the BTEL-GT. The User menu can be accessed either with the keypad or
remotely. A block diagram of the User menu is shown below. The symbol
be accessed with the keypad; the phone symbol
User Menu
<User Code>
<User Code>
Or:
<User Code>
(For different forms of
access see the
respective sections)
When you are in the user menu, input activations are placed in the queue and handled after
you exit from the menu.

Programming by keypad

The BTEL-GT parameters can be programmed locally with a keypad. For clear and quick programming, a voice
menu provides support. When programming by keypad, select the parameter by pressing a series of keys, and
then enter the value for that parameter. Press the
the current menu and go back (if no keys are pressed, the voice messages for the menu level will be repeated 3
times before returning to the previous level). Press the
to press, to speed up programming, you can type the sequence while the voice menu message is being played
without having to wait for the whole message. Pressing the
you to return to standby status. This feature is valid only when exploring the menus or during programming, even
if a voice message from the menu is playing. To return to the menu, you will need to retype the User PIN.
If you use this command during programming, any data entered will be disregarded.
Access the User Menu key by entering the following formula:
where <User PIN> is a 5-digit number (the factory default user PIN is 00000).
Access to programming is indicated by the RED LED
IMPORTANT - Keeping the
you become aware that the PIN that you are typing is invalid, you need to wait a few seconds for the
operation to be cancelled automatically, or press the
CAUTION - If you enter the User PIN during a call to access the User Menu (yellow LED lit), the key inputs
will not be confirmed by a tone but the code will still be accepted and you will access the menu at the
end of the call. You cannot enter the User PIN at the beginning or end of a call (yellow LED switching).

Remote programming

The user can perform some operations remotely with a PSTN or GSM phone (in this case, it needs to be
a touch-tone telephone). Again, voice instructions are provided to assist with programming. For remote
GSM Telephone dialler

USER

indicates the menu items that can be accessed remotely.
Dialer
for
Parameters
Management
Block
for
Calls
Change
for
Code
Dial
for
Number
Phone Book
for
Management
Exit
for

key (the
C
key to enter the data. If you know the keypad sequence
D
key pressed for 3 seconds does not cancel entry of the User PIN. If
indicates the menu items that can
Output
for
Management
Monitor
for
Input
Environment
for
Listen
Management
Back
for
D
key in the phone book settings menu) to exit from
D
key for 3 seconds from any menu level allows
A
C
<User PIN>
turning on (see the section "Status LEDs").
C
key to finish the entry and then try again.
G
Write Phone
for
Book
Read Phone
for
Book
Delete
for
Back
for
19

Publicidad

Tabla de contenido
loading

Tabla de contenido