General Features - Bentel Security BTEL-GT Manual De Instalación Y Usuario

The BTEL-GT is a telephone dialler that can call a series of preset phone numbers, to which it can send both voice
alarms and text messages. The BTEL-GT is available in an ABS plastic container which is placed inside the alarm
system it is connected to. The plastic box is protected against tampering (unauthorized openings) and tearing (optional).
The BTEL-GT does not require any software to set its various options and data, but it can be programmed completely
using an alphanumeric keyboard and a voice menu that can be heard through the speaker on the baseplate.The BTEL-
GT is compatible with all alarm systems and Bentel systems belonging to the NORMA8/NORMA4, KYO, and
ABSOLUTA series. The BTEL-GT's performance depends particularly on GSM network coverage; therefore, it
should not be installed before testing several positions to get the best location for reception (at least one green LED
should be on). For optimal installation, search for the operator with the strongest signal. The BTEL-GT is equipped with:
– 4 programmable alarm inputs. When the input is activated, the dialler can send voice and text messages
to up to 9 numbers.
– 4 OC (Open Collector) type outputs, 3 of which can be programmed and managed either on-site with a
keyboard or remotely via DTMF and SMS, while 1 output is reserved for signaling malfunctions (problems
with the GSM network or low battery).
The BTEL-GT can store 9 telephone numbers of up to 16 digits each. Voice messages can be recorded
directly on the dialler using an internal microphone and played back through a speaker on the baseplate (the
microphone and the speaker are also used for the live function).
This manual provides programming and operation of the telephone dialler.
This Device is fixed and shall be installed by Service Persons only (service person is defined
as a person having the appropriate technical training and experience necessary to be aware of
hazards to which that person may be exposed in performing a task and of measures to
minimize the risks to that person or other persons). It shall be installed and used within an
environment that provides the pollution degree max 2, over voltages category II, in non-
hazardous, indoor locations only. This manual shall be used with the Installation Manual of
the alarm control panel. All instructions specified within that manual must be observed.

General Features

Voice menu in 4 languages for programming
and use.
4 programmable input lines.
Up to 3 voice messages can be associated
with each event: 8 messages lasting up to 8
seconds each.
Checking on the remaining credit for pre-paid
SIM-cards.
Open microphone function.
Speakerphone function.
Sending of voice and text messages to activate
input.
Alarm call activation can be programmed with
commands and programmable polarity options
(positive or negative).
9 telephone numbers (up to 16 digits each) can be
programmed.
Protection from accidental inversion of battery polarity.
Battery and network coverage monitoring.
Programmable by voice and with a keyboard.
1 OC (Open Collector) output reserved for
announcing malfunctions.
3 programmable OC (Open Collector) outputs.
6 signal LED's.
GSM Quad-Band.
Internal antenna.
6
INTRODUCTION
Remote output activation through caller
recognition and/or by sending a text message.
Memory of alarm inputs for handling multiple sends.
Priority for input n.1.
A fourth input can be programmed to block call
cycles.
Remote call cycle blocking.
The number of times to attempt a call can be
programmed.
The number of repetitions for an alarm message
can be programmed.
Searches for the operator with the best GSM
coverage.
Time and date programming.
Periodic voice message.
Periodic text message.
Low battery indicated by text message.
Microphone for recording messages and the live
function.
Speaker for listening to recorded messages and
speakerphone function.
Superkey management.
Digital recording and playing of messages.
Protection from attempts at sabotage (protection
against opening and tearing).
Housing for a 12 V - 1.2 Ah battery (not supplied).
BTEL-GT