Shop-Vac SS16 Serie Manual Del Usuario página 6

CASTER SYSTEM
You will find four caster feet, four casters and four screws with your vacuum.
Assemble as follows:
1. With cord disconnected from receptacle and tank cover removed, turn tank upside down so that bottom
is facing up.
2. With front of tank facing you, take caster feet marked with the letter A and
place in slots on left front and right rear of tank also marked with the letter A.
Secure with screws provided.
3. Take caster feet marked with the letter B and place in slots on right front
and left rear of tank also marked with the letter B. Secure with screws
provided.
4. If flat washers are included in hardware package place flat washer over stem of caster before installing
casters into feet. NOTE: Flat washers are not required with all units.
5. Insert casters into feet by placing stem of caster into holes provided. Apply
pressure and twisting motion until casters snap into place. Return tank to
upright position.
VACUUM SET UP AND OPERATION
DANGER
–
This equipment incorporates parts such as switches, motors or the
like that tend to produce arcs or sparks that can cause an explosion. Do not pick up flammable,
combustible, or hot materials. Do not use around explosive liquids or vapors, as electrical devices
produce arcs or sparks which can cause a fire or explosion - do not use at filling stations or
anywhere gasoline is stored or dispensed.
1. Refer to the filter installation and maintenance section to make sure the correct filters are installed for
normal dry or wet pick up operation based on your cleaning needs.
2. Replace tank cover and apply pressure with thumb to each latch until it snaps tightly
into place. Make sure each latch is clamped securely.
3. Insert machine hose end into inlet located on the front of the tank. Twist slightly to
tighten the connection.
4. Attach the desired cleaning accessory onto the accessory end of the hose.
NOTE: Many more useful tools are available at your local dealer or the Shop-Vac
website.
5. Plug the cord into the wall outlet. Your cleaner is ready for use.
I = ON, O = OFF
FILTER INSTALLATION AND MAINTENANCE
FILTRATION SYSTEM
There are a variety of filters available for your vacuum. There are cage filters that install onto the underside
of the tank cover and tank filters that install into the tank. The filters are grouped into three filtration
categories. General filtration is used for large debris; such as, wood chips, nails and gravel. Medium
filtration is used for medium debris; such as, dirt, sand and sawdust. Fine filtration is used for fine debris;
such as drywall dust, cold ash and cement dust. It is important to have the correct filters installed for your
ASSEMBLY
Screw
Caster
Foot
Screw
Caster
Foot
Caster
Caster
Foot
®
PAGE 5