Publicidad
Idiomas disponibles
Idiomas disponibles
A completely discharged battery (21) needs about three hours to be fully charged. The battery
pack (21) will stay fully charged if connected to power adaptor..
To check available charge, press the button for battery capacity indicator (11). When not in
use, disconnect power adaptor (20) from electrical outlet.
9.1.2
Capacity indicator
There are battery capacity indicators (30) on the battery pack, you can check the capacity
status of the battery if you squeeze the button (11). Those 3 LED might show the status of the
capacity level of the battery:
Display Lights
Three green lights 70 % ~ 100 %
Two green lights
One green light
10
ASSEMBLY
10.1
Folding handle (Fig. 1-2-3)
▪
Attach the lower part of the handle section (14) to the body of the machine, using the nuts
and bolts (Fig. 1).
▪
The nuts of the lower handle (14) must always point to the inside of the machine, the
raised part of spacer plate must point toward the inside of the machine. Tighten fixing
knob .
▪
Mount the upper handle (15) (Fig. 2).
▪
Install the nut into the installation hole of the cam lever (4).
▪
Install the upper handle above the lower handle (Fig. 2).
▪
Pass the bolt through the upper and lower handle, fix it to the cam lever (4) and assemble
knob.
▪
Rotate the cam lever (4) clockwise to the proper position and rotate 180° to lock.
IMPORTANT: Unfold handle carefully so as not to pinch or damage control
cables.
▪
Raise handle until lower handle section locks into place in mowing position. Tighten all
bolts.
▪
Remove protective padding, raise upper handle section into place on lower handle and
tighten both handle knobs.
▪
Assemble the dashboard (16) with use of 4 screws (Fig. 2)
▪
Connecting ignition cable (A) to the brake/stop lever (2): pull out the left hand part of the
brake/stop lever from the upper handle. Bring the end of the ignition cable, which is
attached to the rear of the engine, through the provided slot on the top left side of the
dashboard (16). Hook the end of the cable into the designated opening of the brake/stop
lever.
▪
Hook the brake/stop lever (2) back into the provided opening of the upper handle, Check
the smooth movement of the break/stop lever (2) when pressed and released.
▪
Connecting traction cable (B) to the Drive lever (1): pull out the left hand part of the drive
lever (1) from the upper handle. Connect the end of the traction cable, which connects to
the wheel drive system and coming through the rear frame to the bottom of the mower,
with the hook into the designated opening of the drive lever (1).
▪
Hook the drive lever (1) back into the provided opening of the upper handle, Check the
smooth movement of the drive lever handle when pressed and released.
▪
At the end fix the connection cables from break/stop- and the drive lever on the left upper
side of the lower handle with cable clamp (Fig. 3).
▪
Fix the connection cable from the dashboard (16) to the engine with cable tie.
Copyright © 2024 VARO
Available Charge
10 % ~ 70 %
Less than 10 %
POWXG60300
P a g e
| 10
EN
www.varo.com
Publicidad
