Flex OSE 80-2 Manual De Instrucciones página 16

Operating instructions
WARNING!
Hold the electric power tool by the insulated
grip surfaces only!
CAUTION!
When the power tool is switched off, the
grinding tool continues running briefly.
Switch on the sander and place the

whole sanding sheet on the surface
to be processed.
Applying moderate pressure, move

the sander evenly over the workpiece.
The sanding result is determined

primarily by the selection of the correct
sanding sheet, the selected number
of oscillations and the contact pressure.
Replace sanding sheets in good time.

An excessive increase in the contact

pressure will not increase the grinding
performance, but will increase
the wear on the electric power
tool and the sanding tool.
For further information on the manufac-
turer's products go to www.flex-tools.com.
16
OSE 80-2 / ODE 100-2 / ORE 125-2
Maintenance and care
WARNING!
Before performing any work on the electric
power tool, pull out the mains plug.
Cleaning
Regularly clean the power tool and

ventilation slots.
Using dry compressed air, regularly

blow out the housing interior and motor
through the ventilation slots.
Housing
NOTE
Do not loosen the screws on the housing.
Non-compliance will deem the guarantee
obligations of the manufacturer null and
void.
Repairs
Repairs may be carried out by an authorised
customer service centre only.
Spare parts and accessories
Sanding sheets for different application
areas and other accessories can be found
in the manufacturer's catalogues.
Exploded drawings and spare-part lists
can be found on our homepage:
www.flex-tools.com
Exemption from liability
The manufacturer and his representative
are not liable for any damage and lost profit
due to interruption in business caused
by the product or by an unusable product.
The manufacturer and his representative
are not liable for any damage which was
caused by improper use of the power tool or
by use of the power tool with products from
other manufacturers.