Publicidad
Idiomas disponibles
Idiomas disponibles
Planer Blades
(Fig. 5)
must be handled carefully to avoid injury
to the user or damage to the blades.
blades. Edges are sharp and may cause in-
jury.
The Planer Blades 18 have two cutting edg-
es, and may be reversed when one of the
cutting edges becomes dull or chipped.
Do not attempt to sharpen or use resharp-
ened used blades of any kind. Use only
blades designated for use with this model,
because other blades will cause vibration,
decrease performance and may not clamp
securely in blade holder.
Blade Wrench and Storage Area
(Fig. 4, Fig. 5)
When the Battery Pack 8 has been removed
from the tool, there is a 2.5 mm Blade
Wrench 16 that is conveniently located in
a Storage Area 17 inside the handle base
where it is always handy and unlikely to get
lost or misplaced.
Fig. 4
12
The planer blades are
sharp and fragile and
Wear protective gloves
when changing planer
8
Assembly
Reversing or Replacing Blades
(Fig. 5)
To reverse or replace the Planer Blade 18,
loosen the Clamping Screws 20 with Blade
Wrench 16
slide the Planer Blade 18 lengthwise out of
the Cutter Drum 21, taking care to keep your
fingers away from the sharp edges of the
Planer Blade 18.
If necessary, loosen the clamping element
21 by lightly pushing the element with an
appropriate implement. Example: a wooden
edge. A piece of wood may be used for this
purpose
If the Planer Blade 18 is gummed and dif-
ficult to remove, you may clean the Planer
Blade 18 with mineral spirits, lacquer thin-
ner or alcohol.
Clean all surfaces before reinstalling the
new Planer Blade 18, as this will ensure an
accurate blade setting and proper tool per-
formance.
Fig. 5
21
21
Planer Blade Alignment
17
The Planer Blade 18 should be centered rel-
ative to the front and rear shoes. Rotate the
Cutter Drum 21 by hand to verify that the
Planer Blade 18 doesn't touch to any other
16
part of the tool.
Make sure the Planer Blade 18 sits correctly
in the holder groove of the Cutter Drum 21.
You may then use the Blade Wrench 16 to
tighten the Cutter Drum Clamping Screws
20 which secure the Planer Blade 18 and
your planer is ready for use.
. With the Screws 20 loosened,
.
16
20
20
18
Publicidad
