Schuchmann SWANDOO MARIE INTEGRAL Manual Del Usuario página 42

EN
U
S
Make sure to put the covers back the same way they
previously were. You can follow the previous steps in reverse
order to make sure everything is in place.
REMOVING THE UPPER PART OF THE ARMREST TABLE
SE
S The thorax pads (if used) and the velcro behind the
headrest must be removed.
Lift up the edges of the fabric cover and
loosen it. Pay attention to the area around
the Side Impact Buddy socket, the recline
trigger, and CFA plastic frames. The plastic
Side Impact Buddy socket does not have
to be removed. Pass the harness buckle
through the hole in the crotch pad and
remove the cover from the seat.
To install the fabric cover, follow the steps
above in reverse(46 − 43). For a clean
finish, tuck the fabric edge (
frame of the seat with the help of the
fabric installation tool. You can find it in
the designated pocket on the back of the
headrest cover.
Remove the rubber strap from the
armrest table.
Remove the plastic parts of the cover
from both sides. After washing, follow
the steps in reverse order. Hand washing
recommended.
) into the
T U
42