Publicidad
Idiomas disponibles
Idiomas disponibles
X B E a
2 0
Keep Working
2. Follow instruction for lubricating and changing accessories.
3. Kee handles dry, clean and free from oil and grease.
Cordless grinder safetywarnings
Safety Warnings Common for Grinding, Sanding, Wire Brushing, or Abrasive Cutting-Off Operations:
1. This power tool is intended to function as a grinder, sander, wire brush or cut-off tool. Read all safety warnings, instructions,
illustrations and specifications provided with this power tool. Failure to follow all instructions listed below may result in electric
shock, fire and/or serious injury.
2. Operations such as polishing are not recommended to be performed with this power tool. Operations for which the power tool
was not designed may create a hazard and cause personal injury.
3. Do not use accessories which are not specifically designed and recommended by the tool manufacturer. Just because the
accessory can be attached to your power tool, it does not assure safeoperation.
4. The rated speed of the accessory must be at least equal to the maximum speed marked on the power tool. Accessories
running faster than their rated speed can break and fly apart.
5. The outside diameter and the thickness of your accessory must be within the capacity rating of your power tool. Incorrectly
sized accessories cannot be adequately guarded or controlled.
6. Threaded mounting of accessories must match the grinder spindle thread. For accessories mounted by flanges, the arbour
hole of the accessory must fit the locating diameter of the flange. Accessories that do not match the mounting hardware of the
power tool will run out of balance, vibrate excessively and may cause loss ofcontrol.
7. Do not use a damaged accessory. Before each use inspect the accessory such as abrasive wheels for chips and cracks,
backing pad for cracks, tear or excess wear, wire brush for loose or cracked wires. If power tool or accessory is dropped, inspect
for damage or install an undamaged accessory. After inspecting and installing an accessory, position yourself and bystanders
away from the plane of the rotating accessory and run the power tool at maximum no-load speed for one minute. Damaged
accessories will normally break apart during this test time.
8. Wear personal protective equipment. Depending on application, use face shield, safety goggles or safety glasses. As
appropriate, wear dust mask, hearing protectors, gloves and workshop apron capable of stopping small abrasive or workpiece
fragments. The eye protection must be capable of stopping flying debris generated by various operations. The dust mask or
respirator must be capable of filtrating particles generated by your operation. Prolonged exposure to high intensity noise may
cause hearingloss.
9. Keep bystanders a safe distance away from work area. Anyone entering the work area must wear personal protective
equipment Fragments of workpiece or of a broken accessory may fly away and cause injury beyond immediate area ofoperation.
10. Hold the power tool by insulated gripping surfaces only, when performing an operation where the cutting tool may contact
hidden wiring. Contact with a "live" wire will also make exposed metal parts of the power tool "live" and could give the operator
an electric shock.
KEEP WORKiNG
09
Publicidad
