REMIS REMIfrontIV-D Instrucciones De Montaje página 8

Step 2: (guide pipe must only be fitted with refit version!)
B4
US/GB
B6
Step 3: (installation of front system)
B8
B10
B12
B14
8/32
B4-B7:
B5
If the lower and upper guide pipes are supplied sepa-
rately, the two pipes must be connected using the ad-
hesive supplied together with the accessories. The ad-
hesive is applied to the guide pipe with the thread at
B7
the end without the thread in a sufficient quantity such
that the front area of the aperture is well filled. The
guide pipe with the pin should now quickly be pushed
into the other pipe. The connected pipes should now be
left to harden for 10-15 minutes.
B8:
B9
Remove door rubber seal around A-column cladding.
B9:
Remove upper cladding beginning from the A-column.
Clips are released automatically. Remove cladding
moving upwards.
B10+B11:
B11
cross-
Disconnect cable connection to loudspeaker by pulling
bar
out the plug and remove the loudspeaker.
loud-
speaker
B12-B14:
B13
Figures 12-14 show the REMIS cladding with loud-
speaker grate.
B15:
B15
Clips the loudspeaker in the REMIS cladding. Plug points
upwards.
Important: The same-length
NOTICE!!!
pairs should always be connected!