Publicidad
Idiomas disponibles
Idiomas disponibles
• In the event that the handle needs to be
disassembled, first remove the main body.
Press the spring to release the handle with a
tool (like a screwdriver) and lift the released
handle from the appliance.
Fig.B-2
OPERATION
Preparing for Use
• Before first use, please charge the appliance
for 4~5 hours (refer to "Charging Instructions"
for details).
* Based on results from Tineco lab tests. Lab
temperature 39.2°F (4°C) ~ 104°F (40°C).
1.Press the
button and the appliance will start
in AUTO mode by default. Press it again to turn
off the appliance. Switch between AUTO and
MAX modes by pressing the
Fig.C-1
Tips:
• Solution mode/ Water Only mode:
Appliance starts with Solution mode by default.
Power on while the appliance is upright, hold
for 3s to switch between the two modes.
• Switch to Water Only mode:
LED Loop: Red → Blue (use water only)
• Switch to Solution mode:
LED Loop: Blue → Red (use cleaning solution)
2.The appliance will stop working when put
upright and start running again when reclined.
* Do not recline more than 142° to avoid water
leakage.
Fig.C-2
3.Place the appliance on the charging dock
vertically after use for recharge and storage.
Fig.C-3
Note:
• It is crucial to choose the right mode based on
the CWT contents to achieve the highest level
of dirt detection efficiency.
• Do not vacuum foamed liquid.
Filling Clean Water Tank
1.Press the Clean Water Tank release button to
remove it from the appliance.
Fig.C-4
2.Open the tank cap, and fill with tap water to
the Max line. When deep cleaning is necessary,
add one bottle cap of solution to the CWT and
tightly close the cap.
Fig.C-5
Note:
Only use water under 140°F/60°C.
DO NOT USE HOT WATER.
3.Place the tank back into the appliance. You
should hear a click if done correctly.
Fig.C-6
Charging Instructions
• To charge the appliance, plug in the drying &
button.
charging dock and place the appliance on it.
• To avoid tripping hazards, please place the
appliance on the charging dock near a wall
during charging.
Fig.C-7
• Only charge the appliance with the charger
supplied by Tineco.
• During long periods of not being used, the
appliance must be charged once every 3
months for optimal performance.
• Store indoors in a dry place. Do not expose the
appliance to sunlight or freezing temperatures.
Recommended temperature range:
39.2°F (4°C) ~ 104°F (40°C).
Cleaning Mode Selection
AUTO Mode
• In AUTO mode, the iLoop sensor automatically
detects how dirty the floor is and applies the
appropriate amount of detergent and suction
power.
• A red dirt monitoring loop indicates more dirt
is detected, and a blue loop indicates less dirt
is detected. This mode automatically provides
12
Warning:
Publicidad
