Tineco FLOOR ONE SWITCH S6 Serie Manual De Uso página 17

Brush roller is tangled
Power is off
Start charging
Begin self-cleaning
cycle
Battery insufficient for
self-cleaning
Sufficient battery to
start self cleaning
Cleaning brush roller
Cleaning the pipe
Self-cleaning stopped
Self-cleaning
complete
Main body uninstalled
during selif-cleaning
MAINTENANCE
Note:
• For optimal performance and to prevent odors,
always clean and dry DWT, floater, filters, brush
roller, brush roller cover completely after each
use.
• Please make sure each part is installed correctly
or the appliance may not work properly.
• After maintenance, place the appliance on
the charging dock vertically. Do not expose
the appliance to direct sunlight, and store it
indoors in a dry place.
Main Body
1.To reduce the risk of injury, switch off before
performing maintenance.
Fig.D-1
2.Use a cloth to clean the surface with a neutral
detergent. The cloth should be dry to prevent
Please clean the brush
roller.
Powered off
Charging
Auto-detecting
whether to run self-
cleaning cycle, please
begin self-cleaning
cycle
Battery low, charging
Start self cleaning
Cleaning brush roller
Cleaning the pipe
Please empty and
clean the Dirty Water
Tank.
Please empty and
clean the Dirty Water
Tank.
Please install the main
body
water from entering the appliance.
Fig.D-2
3.Clean the dirt sensor with a damp cloth or the
cleaning tool.
Fig.D-3
Dirty Water Tank
• When dirty water reaches the Max line,
the appliance will stop working and show
a reminder on the display and play a voice
prompt.
• Pull up the tank lid to empty the DWT.
Throw the debris on the waste separator into
the trash.Use the cleaning tool to remove
remaining debris. Rinse the inside of the DWT
and place back into the appliance. separate
hair and debris from dirty water.
Fig.D-4
Dry Filter & Waste Separator
Grasp recessed area on each side of the dry filter
and pull upward. Rinse under running water and
must be completely dry before recombining with
the lid of the DWT.
*A spare dry filter is provided with your appliance
for convenient replacement.
The waste separator can be removed and rinsed
under the running water.
*The function of the waste separator is to
separate solid waste.
*The appliance can function normally without the
waste separator, so users can decide whether to
keep it or not.
Fig.D-5
Brush Roller Self-cleaning
1.Place the appliance on the charging dock after
use, the sensor will auto-detect the level of dirt.
2.When you hear the voice prompt "please
begin self-cleaning cycle", press the self-
cleaning button and begin the process.
3.Once complete, you will hear the voice prompt
"self-cleaning completed, please clean the
Dirty Water Tank." At this point, the appliance
will begin charging.
Fig.D-6
15