Tineco FLOOR ONE SWITCH S6 Serie Manual De Uso página 15

the best cleaning solution.
Fig.C-8
MAX Mode
• In AUTO mode, press the
MAX mode.
• In Max mode, the appliance will apply max
suction power and will spray water/solution for
deeper cleaning.
Fig.C-9
ECO Mode (Hand Vac)
• When the main body is used as a hand vac, the
appliance will start in ECO mode by default.
In ECO mode,the appliance will apply proper
suction power to ensure long battery life.
Fig.C-10
MAX Mode (Hand Vac)
• Press the button to switch to MAX mode
while using the hand vac.
Fig.C-11
Note:
Keep sharp objects away from the digital display
screen to avoid scratches and scrapes.
Usage of Hand Vac
1.Install the dustbin to the main body properly
and it clicks into place.
2.Attach the accessory tool onto the dustbin, it
will click into position when correctly fitted.
Fig.C-12
• Insert the drying & charging dock into the
vacuum dock as shown. Installation is complete
when you hear a click.
• Place the appliance and accessories on the
vacuum dock for convenient storage after use.
Fig.C-13
• Press the release button to remove the dustbin.
• Pull out the mesh filter as above and empty the
contents.
• Press the HEPA lock button to take out the
HEPA and sponge filter, clean both parts with
the cleaning tool.
Fig.C-14
Note:
• Clean the dustbin and filters after each use.
• To maintain high performance, wash and dry
button to enter
• Air dry completely before reinstalling.
Runtime
• The runtime for the Floor Washer is about 35
• The runtime for the Hand Vac is about
• Estimated runtime data was obtained by
Charging Time
• A full charge takes approximately 4~5 hours.
• Estimated data was obtained by Tineco
Indicator
When in Use
13
the sponge filter monthly, replacing it every
6 months. Wash and dry the HEPA filter every
3 months, replacing it every 12 months.
minutes.
65 minutes.
Tineco Laboratory.
Laboratory using ambient temperatures
ranging from 39.2°F (4°C) to 104°F (40°C).
Battery level ＞ 20%: solid
green indicator.
Battery level 10%~20%: solid
red battery indicator.
Battery level < 10%: battery
indicator blinking red.
Battery level ≤ 10%: battery
indicator will be blinking.
Off: no power detected or
possible battery malfunction.
Indicator blinking: CWT is
empty.