Publicidad
Idiomas disponibles
Idiomas disponibles
NOTICE!
Possible material damage!
There is a risk of damage to the appliance if
installed incorrectly.
Place the microwave on a level, stable
surface which is able to carry the weight
of the appliance as well as the maximum
weight of the food which will be cooked
in it.
Use the appliance indoors only.
Do not place the microwave:
– near sources of heat or naked flames
– near radios or televisions
– in the immediate vicinity of inflamma-
ble materials
– in a location prone to wetness or high
humidity.
– in a location with extremely high or
low temperatures or in direct sunlight.
Chemical additives in furniture coatings may
corrode the material of the appliance feet
and cause residue on the furniture surface.
Place the appliance on a heat-resistant
mat if necessary.
Connect the microwave to a convenient
and easily accessible, earthed mains
socket.
6.2. Heating up the empty
appliance
Before using the microwave, the appliance
must be heated up so that residues left over
from production can evaporate. To do this,
switch on the appliance in hot air mode with-
out food or accessories inside as described
below:
Open the door and remove any packag-
ing or accessory parts from the cooking
compartment.
Close the door again.
Press the
button.
The display shows 100 °C.
Press
or
to set the cooking tem-
perature to °C.
Press the
button to confirm the set-
ting.
Press
or
to set a cooking time of
10 minutes.
Press the
button again to start the
heating process.
During this initial heating period you may
notice faint odours. These smells are not dan-
gerous and will disappear after a short time.
Ensure adequate ventilation, e.g. by opening
a window.
The appliance switches off automatically
after 10 minutes. Wait until it has com-
pletely cooled down.
Pull the mains plug out of the mains
socket and then clean the appliance once
again using a damp cloth from inside and
dry the microwave carefully.
6.3. Using accessories
Fig. 4 – Insert turntable plate
Do not use the microwave without prop-
erly installing the turntable plate.
Check that the drive shaft is correctly in-
serted in the recess on the base of the in-
side of the microwave and that its wings
rest flat on the base. If necessary, turn the
shaft until it drops down into its correct
position.
DE
FR
NL
ES
IT
EN
105
Publicidad
