WAGNER STEAMFORCE SPEED PRO Guia Del Usuario página 23

SteamForce Speed Pro
6. Extension Leads EU/UK
If you are using an extension lead it must be rated at a minimum of 13 Amps and fully
unwound. Do not operate with an extension lead rated less than 13 Amps as this will cause
premature failure of the element which is not covered by the guarantee.
7. Preparation
Prepare the old wallpaper well so that you can remove it as quickly as possible
and thus in an energy-efficient way.
To achieve fast paper removal always gently score the areas to be
stripped. With heavily embossed, vinyl-coated or painted papers this is
essential. Either use a proprietary perforator tool or alternatively score
the paper with the edge of a wall scraper in a 'criss-cross' pattern with
15 cm spacing. As with all decorating work be sure to protect carpets
and furniture with covers.
8. Operation
•
Place the unit on a flat surface near the area to be stripped.
•
Open the lid of the device and remove the hose, the steam plates and the power cable.
•
Hold the water tank by the sides and pull it out of the device (Fig. 3).
•
Place the water tank on a flat surface with the tank opening facing upwards, unscrew
the tank cap and fill with clean water (no hot water). (Fig. 4). Do not use additives - do
not overfill.
•
Screw the tank cap back in place and check that it is tight.
•
Put the water tank back into the device.
•
Fully uncoil the hose and supply cord.
•
Screw hose onto threaded outlets of boiler and steamplate, securely by hand. Do not
overtighten (Fig. 5).
•
Connect the supply cord from the unit to the socket-outlet and switch on.
Caution! Beware of hot water discharge prior to steam emission.
•
lt can take up to 4 mins (approx.) before steam is produced - depending on fill water
temperature. DO NOT leave unattended.
•
Once steam is being produced at the steamplate you are ready to commence operation.
CAUTION! CAUTION! WARNING: Hot liquid or steam can burn.
Danger of scalding! Steam may also condense into
boiling droplets. Steam should not be directed towards
electrical appliances.
EN
23