Publicidad
Idiomas disponibles
Idiomas disponibles
EN
Note: When starting the product with a new chain, it is
recommended to conduct a test run for 2-3 minutes. A
new chain may stretch slightly during initial use. After
the test run, check the chain tension and tighten if
necessary to ensure optimal performance.
4
OPERATION
This section describes how to operate the product.
CAREFULLY READ AND UNDERSTAND
THE SAFETY CHAPTER AND OPERATION
INSTRUCTIONS BEFORE YOU OPERATE THE
PRODUCT.
4.1
BEFORE YOU USE THE PRODUCT
4.1.1
CONNECT THE BATTERY CHARGER
1.
Connect the battery charger to the proper voltage
and frequency that is specified on the rating plate.
2.
Refer to the Battery Charger Operator Manual for
information about how to use the battery charger.
4.1.2
CHARGE THE BATTERY
Refer to the Battery Charger Operator Manual for
information about how to use the battery charger.
4.1.3
BATTERY INFORMATION
Refer to the Battery Operator Manual for information
about how to use the battery.
4.1.4
ADD BAR AND CHAIN OIL
To ensure safe and proper operation, use only clean
and uncontaminated bar and chain oil (not included).
Avoid using dirty, used, or contaminated oil as it can
cause damage to the bar or chain. Consult nearest
service center for oil recommendations.
INSUFFICIENT CHAIN OIL CAN RESULT IN THE
BREAKAGE OF THE SAW CHAIN, POSING A
SIGNIFICANT RISK OF SERIOUS INJURY OR
DEATH TO THE OPERATOR.
WARNING
IMPORTANT
WARNING
English
ENSURE THAT THE BATTERY IS NOT INSERTED
IN THE PRODUCT BEFORE ADDING BAR AND
CHAIN OIL.
1.
Place the product on a flat and stable surface,
ensuring the oil cap is facing upward.
2.
Flip up the oil cap lever and rotate it
counterclockwise to detach the oil cap.
3.
Pour the appropriate oil into the oil tank, taking
care to prevent any spills or leaks. Wipe off any
excess oil from the opening.
4.
Keep a watchful eye on the oil window to prevent
any dirt or debris from entering the oil tank while
adding the oil.
5.
Securely tighten the oil cap by turning it clockwise
until it is snugly fitted in place.
4.1.5
CONNECT THE BATTERY TO THE
PRODUCT
ONLY USE THE ORIGINAL BATTERY WITH THE
PRODUCT.
1.
Make sure that the battery is fully charged.
2.
Push the battery into the battery compartment.
The battery locks into position when you hear a
click.
10
WARNING
WARNING
Publicidad
