Edesa EFC-7832 DNF EX /B Manual De Instrucciones página 16

14
EN
MAINTENANCE AND CLEANING
CAUTION
Disconnect the appliance from the electrical
supply before ndertaking any routine
maintenance. Allow at least 5 minutes before
restarting the appliance, as frequent starting
may damage the compressor.
Do not use mechanical devices or other
means to accelerate the defrosting process,
other than those recommended by the
manufacturer.
Do not try to repair, disassemble or modify
the appliance by yourself. In case of repair
please contact our customer service.
Eliminate the dust on the back of the unit at
least once in the year to avoid hazard by fire,
as well as increased energy consumption.
Check the door gasket regularly to make sure
there are no debris. Clean the door gasket
with a soft cloth dampened with soapy water
or diluted detergent.
The interior of the product should be
cleaned regularly to avoid odor.
Use a soft cloth or sponge to clean the
inside of the product, with two tablespoons
of baking soda and a quart of warm water.
Then rinse with water and wipe clean.
After cleaning, open the door and let it dry
naturally before turning on the power.
For areas that are difficult to clean in the
product (such as narrow sandwiches, gaps
or corners), it is recommended to wipe them
regularly with a soft rag, soft brush, etc.
and when necessary, combined with some
auxiliary tools (such as thin sticks) to ensure
no contaminants or bacterials accumulation
in these areas.
Wipe the outer surface of the product with
a soft cloth dampened with soapy water,
detergent, etc., and then wipe dry.
Do not use hard brushes, clean steel
balls, wire brushes, abrasives (such as
toothpastes), organic solvents (such as
alcohol, acetone, Isoamyl acetate, etc.),
boiling water, acid or alkaline items, which
may damage the fridge surface and interior.
Boiling water and organic solvents such as
benzene may deform or damage plastic
parts.
Maintenance and cleaning
Do not rinse directly with water or other
liquids during cleaning to avoid short circuits
or affect electrical insulation after immersion
Defrosting
Although this appliance automatically
defrosts, a layer of frost may occur on the
freezer compartment's interior walls if the
freezer door is opened frequently or kept
open too long. If the frost is too thick, choose
a time when the supply of food stocks are
low and proceed as follows:
1. Remove existing food and accessories
baskets, unplug the appliance from
the mains power and leave the doors
open. Ventilate the room thoroughly to
accelerate the thawing process.
2. When defrosting is completed, clean
your freezer as described above.
CAUTION! Don't use sharp objects to
remove frost from the freezer. Only
after the interior completely dry should
the appliance be switched back on and
plugged back into the mains socket.
ATTENTION
The appliance shall run continuously once
it is started. Generally, the operation of the
appliance shall not be interrupted;otherwise
the service life may be impaired