Publicidad
TROUBLESHOOTING
Incorrect operations are often mistaken for trouble and malfunctions. If you think that there is something wrong with this component,
check the points below. Sometimes
the trouble may lie in another component.
Investigate the other components
and electrical
appliances being used.
If the trouble cannot be rectified even after exercising the checks listed below, ask your nearest PIONEER authorized service center or
your dealer to carry out repair work.
Symptom
Cause
Remedy
No power supplied to unit.
e Power plug is disconnected from outlet.
@ The component power plug has been plugged
into another component power outlet (e.g.
timer, etc.) but power to that unit is
disconnected.
e@ POWER switch is set to STANDBY.
elnsert plug securely into outlet.
e@ Turn on power to the other component.
ePress the POWER switch to ON so that the
STANDBY indicator goes off.
No sound.
eConnecting cords are disconnected from
terminals, or connected incorrectly.
e Terminals, or connecting cords pin plugs are
dirty.
eThe input selector switch is not set to the
desired input source.
e Operation of other components is incorrect.
e Connect securely.
Clean terminals and plugs.
eSet switch correctly (PHONO, TUNER, CD,
LINE, TAPE 1/DAT, TAPE 2/CDR).
eConsult the operating instructions for the
other components.
No sound from one speaker.
eConnecting
cords
or speaker
cords
are
disconnected on that side.
e Connect securely.
Cannot record tapes.
The position of REC OUT switch is setto OFF.
| eSet
switch
correctly
(see
section
"RECORDING TAPES").
e@ Reconnect properly.
eConsult the operating instructions of the
cassette deck.
eConnections are incorrect.
e@ Operation of cassette deck is incorrect.
Cannot perform tape copying.
e The position of REC OUT switch is setto OFF. | eSet switch correctly (see section "COPYING
TAPES").
eConsult the operating instructions of the
cassette deck.
e Operation of cassette decks is incorrect.
The remote control unit does not | eBatteries are dead or no batteries in remote | elnsert new batteries (see page 18).
work.
control unit.
eThe remote control sensor is not receiving | eOperate the remote control unit within a
any signals.
range of 7 meters and an angle of 30 degrees
(refer to page 18).
eA fluorescent light is shining on the remote
| eMove so fluorescent light does not shine
sensor window.
directly on amplifier's front panel remote
sensor window.
Abnormal functioning of this unit may be caused by static electricity,
or other external interference. To restore normal operation, turn the
power off and-then on again, or unplug the AC power cord and then
plug it in again.
22
<ARE7053>
En
soscatmontaen
yen
atto
sentient
et
BH
SEE
RAPHE
SHNRNAN
OI NS
svseren
er
Publicidad
