ASSEMBLY
Place the wheel wrench on the arbor nut then slide the
arbor wrench into the arbor.
Holding the arbor wrench firmly to prevent movement,
turn the wheel wrench counterclockwise to loosen.
Remove the arbor nut and outer washer leaving the inner
washer on the arbor.
WARNING:
If inner washer has been removed, replace it before
placing wheel on arbor. Failure to do so could
cause an accident since the wheel will not tighten
properly. Never use wheels that have openings,
grooves, or teeth on this tool.
Place the cutting wheel onto arbor with the arrows on
wheel going in the counterclockwise direction.
Replace the outer washer. The double "D" flats on the
washers align with the flats on the arbor.
Replace the arbor nut on the arbor. Using wheel wrench
and arbor wrench, tighten arbor nut securely.
NOTE: Two water nozzles come installed on this product.
The hole in each nozzle should face the cutting wheel.
Close the upper wheel guard and tighten the wheel guard
lock securely.
INSTALLING THE MITER GUIDE
See Figure 15.
The miter guide can be used from both the left and right side
of the cutting wheel.
Place the slot on the underside of the miter guide on the
sliding table fence.
Lock the miter guide securely to the table by turning the
lock knob clockwise.
To adjust angles:
Loosen the miter knob.
Rotate to the desired angle by moving the guide left or right.
Tighten the knob securely before turning on the saw.
FILLING/CHANGING THE WATER RESERVOIR
See Figures 16 - 17.
Fill the water reservoir with clean tap water to the fill line.
Do not fill past the Max Fill line on the tray.
To change reservoir water:
Unplug the saw.
Remove the drain plug and empty waste water into a
bucket. Do not allow the water to splash onto the ground
or around the machine.
Rinse the water reservoir thoroughly.
Discard the waste water in accordance with local
regulations.
Replace the drain plug and refill tray with clean water.
45
FILL LINE
16 — English
MITER
KNOB
MITER
GUIDE
SLOT
DRAIN
PLUG
LOCK
KNOB
Fig. 15
WATER
RESERVOIR
Fig. 16
Fig. 17