RIDGID R40401 Manual Del Operador página 14

ASSEMBLY
INSTALLING THE SLIDING TABLE
See Figure 10.
To install the sliding table:
 Grasp the table firmly and set the rollers on the front of
rails.
 Holding the table parallel with the frame, push the table
toward the back of the saw.
 When the table lock lever reaches the stop on the front
rail on the right hand side of the frame, pull the lever out
and hold it out until the lock has passed the stop. Release
the lever.
 Slide the table along the rails until the final rollers engage
the rails.
To lock sliding table:
 Pull the table lock lever out and turn 90˚ counterclockwise.
 Release the lever.
NOTE: When the sliding table is installed, and you push
the table, it will "click" into place. This is the table lock
lever snapping into a hole in the frame locking the table
in place.
To unlock the sliding table:
 Pull the table lock lever out and turn 90˚ clockwise.
TILE CUTTING WHEEL
For maximum performance and safety, it is recommended
that you use the 8 in. cutting wheel provided with your
saw. Additional cutting wheels of the same high quality are
available at your local dealer.
WARNING:
Do not use cutting wheels rated less than the no
load speed of this tool. Failure to heed this warning
could result in personal injury. Do not use wheel
with cracks, gaps, or teeth.
INSTALLING THE CUTTING WHEEL
See Figure 11.
WARNING:
A 8 in. tile cutting wheel is the maximum wheel
capacity of the saw. Never use a wheel that is
too thick to allow wheel washer to engage with
the flats on the arbor. Larger wheels will come
in contact with the splash hood, while thicker
wheels will prevent the wheel bolt from securing
the wheel on the arbor. Either of these situations
could result in a serious accident and can cause
serious personal injury.
 Unplug the saw.
 Lock table in front position.
 Loosen wheel guard knob by turning counterclockwise
and open the cutting wheel guard.
TABLE LOCK
WHEEL
WRENCH
WATER
NOZZLES
14 — English
LOCK
LEVER
SLIDING
TABLE
ROLLERS
OUTER
WATER
NOZZLE
6 mm HEX
WRENCH
INNER
WASHER
OUTER
WASHER
ARBOR
CUTTING
WHEEL
ARBOR
UNLOCK
BYPASS
SAW
FRONT
Fig. 10
WHEEL GUARD
KNOB
CUTTING WHEEL
GUARD
NUT
Fig. 11