RIDGID R40401 Manual Del Operador página 27

ADJUSTMENTS
To adjust the lower cam rollers:
 Use 6 mm hex key to hold cam bolt nut. Use the 10 mm
wrench to loosen the cam bolts.
 Make height adjustments by turning cam roller.
 Once the rollers are touching the rail, tighten the cam bolt
nut securely. Repeat for each roller as required.
NOTE: Check that rollers are sliding properly after each
adjustment.
To adjust the right side cam rollers:
Only front and back roller can be adjusted on the right side.
 Use wrench to hold cam bolt nut. Use 6 mm hex wrench
to loosen cam bolts.
 Make height adjustments by turning cam roller.
 Once the rollers are touching the rail, tighten the cam bolt
nut securely. Repeat for each roller as required.
NOTE: Check that rollers are sliding properly after each
adjustment.
DEPTH STOP ADJUSTMENTS
See Figure 39.
The depth stop limits the cutting wheel's downward travel.
It allows the wheel to go below the table enough to maintain
full cutting capacities. The depth stop is factory set to provide
maximum cutting capacity for the wheel provided with the
saw. Make adjustments if needed.
 Unplug the saw.
 To adjust the depth, loosen the wing nut located on the
depth stop.
LOWER CAM ROLLER
ADJUSTMENT
 Turn the depth stop knob. Set the wheel to the correct
cutting depth (wheel just below the table surface). Lower
the cutting wheel to the table to check wheel clearance.
 Readjust if necessary.
 Tighten the wing nut.
Fig. 37
27 — English
ROLLER
RAIL
DEPTH
STOP
KNOB
ADJUST
Fig. 38
WING
NUT
Fig. 39