Husqvarna RedMax GZ3500T Manual Del Usuario página 20

2. Push the start/stop switch to the STOP position. The
engine must stop.
To do a check of the muffler
1. Loosen the screws (A and B).
A
2. Remove the muffler cover.
3. Loosen the screws and nuts.
4. Remove the muffler and make sure that it is not
defective.
20
5. Assemble the muffler and make sure that it is
correctly attached to the product.
6. Some mufflers have a special spark arrestor mesh.
Clean the spark arrestor mesh one time each week if
your product has this type of muffler.
B
Carburetor adjustment
Because of environmental and emissions laws, your
product has adjustment limitations on the carburetor
adjuster screws. This decreases the harmful exhaust
fumes from your product. You can only turn the
adjustment screws maximum ½ turn.
Basic adjustments and run-in
The basic carburetor adjustments are done at the
factory. For the recommended idle speed, refer to
Technical data on page 30 .
CAUTION: Do not operate the product at too
high speed during the first 10 hours of
operation.
995 - 004 - 05.11.2019
1/2
1/2