MPM MKW-11M Manual De Instrucciones página 51

COFFEE BEAN COMPARTMENT LID EMPTYING
1. Press and hold the Clear grinder
the device will start the compartment emptying function. At the same
time the coffee bean compartment emptying button
permanent basis and other function indicators will go off.
2. Open the door and remove the grounds container, pour out the ground
coffee from it into another container.
3. After the work is finished, fit the elements properly and the device will
automatically switch to the standby mode.
4. Press and hold the coffee bean compartment emptying
wish to cancel the current function.
CAUTION! The coffee bean compartment emptying function will only be active for 15 seconds.
The above-mentioned operation must be repeated each time when there is not much coffee
beans left in the compartment.
SETTING UP THE DEVICE
SETTING THE AMOUNT OF DISPENSED COFFEE AND MILK
1. Dispensed coffee amount setting operation:
While dispensing coffee, press and hold the selected function button (Espresso, Dou-
ble Espresso, Americano); the device gives sound signals and the relevant function but-
ton icon will begin to flash. At this time, the device will switch to the mode responsible
for setting the amount of dispensed coffee. When the coffee in the cup reaches the
required level, release the selected function button - the newly set amount of dosed
coffee will be saved.
The scope of amount of the dispensed coffee is as follows:
single Espresso cup approximately 30-100 ml
-
double Espresso approximately 30-100ml * 2
-
Americano approximately 110-180ml
-
2. Operation of setting the amount of dispensed milk and coffee:
CAUTION! For Cappuccino and Latte, set the amount of dispensed coffee and the amount of
dosed milk separately.
While dispensing milk/coffee, press and hold the selected function button (Latte and
Cappuccino); the device gives sound signals and the relevant function button icon will
begin to flash. At this time, the device will switch to the mode responsible for setting the
amount of dispensed milk/coffee. When the milk/coffee in the cup reaches the required
level, release the selected function button - the newly set amount of dosed milk/coffee
will be saved. The operation of setting the amount of dispensed milk/coffee applies only
to the "Cappuccino" and "Latte" function.
The scope of amount of the dispensed milk/coffee is as follows:
- Cappuccino approximately 30-100ml coffee + milk -10-40 seconds
- Latte: milk 10-40 seconds + coffee approximately 30-100ml
ATTENTION! The quantities given are dependent on the type of coffee and grinding thickness.
button for at least 1 second and
will light up on a
button for at least 3 seconds, if you
EN
51