MPM MKW-11M Manual De Instrucciones página 53

CLEANING THE MILK FROTHER
After the coffee brewing process comes to an end or if the froth-
er does not foam the milk properly, then remove the coffee outlet
cover and dismantle the frother. Disassemble the frother into three
parts and wash thoroughly under running water with a mild detergent.
Wipe it dry and fit it properly in place.
CLEANING THE DRIP TRAY
Empty the drip tray every day. Remove the drip tray and wash it under running water with
a mild detergent. Wipe it dry and fit it properly in place.
CLEANING THE COFFEE GRINDER
It is recommended to clean the coffee grinder once in two weeks. If there i coffee in the
coffee bean compartment, empty it (see section: Use of the device - Coffee bean com-
partment emptying
1. Remove the coffee bean compartment lid
2. Turn the grinding level adjustment knob counterclockwise.
3. Using the handle, unscrew the upper burr counterclockwise.
4. Clean the grinding compartment and the grinder using the cleaning brush.
5. Do not insert the upper burr, replace the coffee grinding level adjustment knob again in order to
empty the grinder from the rest of the coffee.
6. Then press and hold the Clear grinder
compartment emptying function. If there still coffee in the compartment, repeat the operation.
7. Open the service door and remove the ground coffee from the dispenser channel using the clean-
ing brush and grounds container, and then close the service door.
8. After grinder cleaning process comes to an end, turn the grinding level adjustment knob counter-
clockwise.
9. Close the upper burr by turning it counterclockwise.
10. Close the grinding level adjustment knob clockwise and set the preferred coffee grinding coarse-
ness.
CAUTION! Never make grinding level adjustments when the coffee is in the compartment and
the grinder is not running. This can damage the grinder.
CLEANING THE DEAD CORNER OF THE BREWER
It is recommended to clean the dead corner of the brewer once a week.
1. When the device is on, press and hold the Clean
in order to switch to the mode responsible for the cleaning of the dead corner of the brewer.
2. After switching to the brewer cleaning function, the brewer will move to the left side of the device.
3. After the service door is opened (the device remains in the state of safe protection), you can clean
the dead corner of the brewer with a brush.
4. When the cleaning is over, close the service door.
5. Press and hold the Clean
cleaning function.
button for at least 1 second and the device will start the
and Double Espresso buttons
and Double Espresso buttons
for 1 second
for 1 second, in order to exit the
EN
53