Defi Nitions: Safety Guidelines; Tools Required - DeWalt DWE74911 Manual De Instrucciones

Defi nitions: Safety Guidelines
The definitions below describe the level of severity for each
signal word. Please read the manual and pay attention to these
symbols.
DANGER: Indicates an imminently hazardous situation
which, if not avoided, will result in death or serious injury.
WARNING: Indicates a potentially hazardous situation which,
if not avoided, could result in death or serious injury.
CAUTION: Indicates a potentially hazardous situation which, if
not avoided, may result in minor or moderate injury.
NOTICE: Indicates a practice not related to personal injury
which, if not avoided, may result in property damage.
IF YOU HAVE ANY QUESTIONS OR COMMENTS ABOUT THIS OR
ANY D WALT TOOL, CALL US TOLL FREE AT:
E
1-800-4-D WALT (1-800-433-9258)
E
DW74911 Rolling Table Saw Stand with
Folding Legs
WARNING: For your own safety, read the table saw instruction
manual before using any accessory. Failure to heed these warnings
may result in personal injury and serious damage to the table saw
and the accessory. When servicing this tool, use only identical
replacement parts.
This stand is designed for use with table saws only. This stand has
been evaluated by UL for use with the DWE7490, DWE7491, and
DWE7499 table saws. If you experience a problem with your D
purchase, please call 1-800-4-D
E
WALT
E
WALT (1-800-433-9258).

Tools Required

Hex key and small wrench (supplied)
Socket or wrench set
Contents
Stand, right side
Stand, left side
Wheels (2)
Rear axle
Kickstand assembly
Tube plugs (2)
Handle assembly
Handle feet (2)
Carriage head bolts (2)
M6x12 pan bolts (2)
M8x40 hex head bolts (4)
M8x40 pan head bolts (4)
M8 lock nuts (12)
Flat washers (2)
Saw mounting hardware: M8x75 pan head bolts (4)
M8 lock nuts (4)
General Safety Instructions for Table Saw
Accessories
WARNING: To reduce the risk of personal injury:
• ALWAYS use eye protection. All users and bystanders must
wear eye protection that conforms to ANSI Z87.1.
• Ensure all stand fasteners are securely fastened and that all
stand mechanisms are in proper working order before operating
the table saw.
2