DeWalt DWE74911 Manual De Instrucciones página 5

• DO NOT exceed the weight this stand can hold. The DWE74911
table saw stand is designed to support 150 lbs. (68 kgs.) safely
in a work environment. It is unsafe to climb, sit or stand on the
stand.
• Follow the mounting instructions carefully. Fasten the saw securely
to the stand as instructed.
• DO NOT modify or use stand for operations for which it is
unintended.
• DO NOT use the stand on uneven surfaces. DO NOT use the
stand with the legs folded and stand sitting on the ground. The
stand is designed to be used on a flat, stable surface.
ASSEMBLY
Assembling Stand Frame Halves (Fig. 2)
1. Slide smaller tube diameter into opposite
tube side as shown until holes align.
2. Install M6x12 pan head bolts until tight on
both sides.
Attaching the Wheels
and Axle (Fig. 3)
1. Attach the axle (A) to the end bracket
(J) by aligning the pre-drilled holes.
Secure axle to end bracket
two carriage bolts and lock nuts provided.
2. Place the wheels (B) on the axle (A) and
secure with washers and lock nuts as
shown. Tighten wheel and axle nuts securely.
Attaching the Kickstand (Fig. 4)
Insert the tube plugs (K) into the end of the kickstand tube (L). Be sure
that the holes (M) in the tube plugs are in line with the holes (N) in the
kickstand tube before inserting the tube plugs.
Align the kickstand holes with the holes on the end bracket. Be sure
FIG. 2
the kickstand is pointing up when the stand is in an upright position.
Secure the kickstand with the four M8x45 pan bolts and nuts
provided as shown.
using
3
FIG. 3
B
J
A
FIG. 4
N
N
L
M
M
K
B
K