DeWalt DWE74911 Manual De Instrucciones página 6

Attaching the Handle
(Fig. 5)
Attach the handle with the four
M8x45 hex head bolts provided.
Feed the bolts through the handle
feet then through the handle tube
and through the gusset holes on
the end bracket. Install four nuts
and tighten securely. NOTE: The
handle has two positions to choose
from: a compact position and an
easy carry/setup position.
Table Saw Mounting (Fig. 6)
WARNING: To reduce the risk of injury, turn unit off,
disconnect machine from power source before assembling
the table saw to the table saw stand. An accidental start-up can
cause injury.
WARNING: For your own safety, read and understand the table
saw instruction manual before using. Failure to heed these warnings
may result in personal injury and serious damage to the table saw and
the accessory.
1. Place the saw, table side down, on a stable, non-marring surface.
2. Place the stand on top of saw as shown. Align the stand holes
with the saw frame holes.
3. Feed the M8x75 pan head bolts through the stand frame then
through the saw frame. Secure with an M8 lock nut from top and
tighten in each of the four hole locations.
4. Lift assembly by stand handle onto kickstand.
FIG. 5
saw is fully anchored on the stand.
objects from the handle. The stand may tip when downward force
is applied.
To Raise Stand from Collapsed Position
Roll the stand to the workspace. Be sure the area is flat and stable
before attempting to set up the saw and stand.
4
FIG. 6
WARNING: To reduce the risk of personal injury, be sure the table
WARNING: To reduce the risk of personal injury, do not hang
1. Tilt up the stand until the saw is at a 90 degree angle sitting on
the kickstand.
2. Unfold the handle side legs by depressing leg release levers and
rotate until locking pin clicks into the detent. Repeat for other
handle side leg.
3. Unfold the wheel side legs by rotating leg release levers and rotate
leg until locking pin clicks into the detent. Repeat for other bottom
leg.