STAMOS S-ALU 220 Manual De Instrucciones página 16

Pulsation function switch-key = Additional pulsation function
makes it possible to prove more energy without the necessity
15
to significantly increase the temperature in the welded element.
On
16 Switch-key / Breaker switch
Off
TIG / WIG connector
17
18
MMA connection
TIG / WIG connector
19
Foot-operated connector
20
21 Mass conduit connector
GAS
Gas / air connection at the rear side of the welder
22
AIR
Earthing = at the rear side of each and every welder there is
a bolt with earthing marking. Before starting, the device has to
23
be earthed with the conduit which cross section can not be
smaller than 6 mm. It could protect against voltage loss.
30
EN
Rev. 28.04.2022 Rev. 28.04.2022
EN
31