Vaporesso GEN MAX/SE Manual De Instrucciones página 5

PROTECTIONS
1. Short circuit protection & Low resistance protection:
When the load resistance is less than 0.1 Ω, press the ignition key devise will enter the
short circuit protection and close the output, screen will display "SHORT ATOMIZER".
2. Low resistance protection:
When the load resistance is less than 0.1 Ω, press the ignition key devise will enter the
Low resistance protection and close the output, screen will display "LOW RESISTANCE".
3. No load protection:
When no load resistance is detected, press power button could trigger the no load
protection, the device will close the output, at the same time OLED display will show
"CHECK ATOMIZER".
4. High resistance protection:
When the load resistance is larger than 5Ω, press power button could trigger the high
resistance protection, the device will close the output, at the same time OLED display
will show " CHECK ATOMIZER ".
5. Low voltage protection:
When the voltage of the battery cell is lower than 3.3V, press power button could trigger
the low voltage protection, the device will close the output, at the same time OLED
display will show "BATTERY LOW".
6. PCBA(Printed Circuit Board Assembly):
When the temperature of PCBA sensor reaches 60-75 degrees, screen display "OVER
HEAT" and output is closed.
7. Over discharge protection:
During the charging, the battery voltage will rises to 4.1V+/-0.05V,the screen will display
"100%"
8. USB High Voltage Input Protection:
Switching in the charger, stop charging when the input voltage to USB port exceeds 6V
and is lower than 30V.
9. Over charge protection:
During the charging, the battery voltage will rises to 4.2V+/-0.3V,the screen will display
"100%"
10. Auto-shut off protection
When POWER button is held for 10±1 seconds, the device will close the output, at the
same time OLED display will show "OVER TIME".