Publicidad
Idiomas disponibles
Idiomas disponibles
USE THE CORRECT CLEANING FLUID
If the paint being used was water based (acrylic paint), use ONLY WATER when
performing the cleaning procedure.
NOTE• USING SOLVENT-BASED CLEANING FLUID ON WATER-BASED PAINTS WILL
RESULT IN A SUBSTANCE THAT WILL BE EXTREMELY DIFFICULT TO CLEAN.
If the paint or coating material being used was oil-based (enamel paint, lacquer, etc.),
refer to the coating material's label or MSDS to determine what solvent to use. These
solvent-based cleaning fluids are safe to use in the airless sprayer:
·Mineral Turpentine
·Paint Thinner
CLEANING THE SPRAYER
1.Start cleaning the sprayer IMMEDIATELY after use by following the PRESSURE
RELIEF PROCEDURE on 9.
2.Use a wrench to remove the Nozzle Tip Guard (Q) and Nozzle Spray Tip (P)
from the gun and place it into the cleaning fluid.
3.Separate the Primer Output Tube (H) from the Suction Tube (J). Place the
Primer Output Tube
(H) into a waste pail, and the Suction Tube with Inlet Screen (K) into a pail that
contains water or flushing solvent (read section titled USE THE CORRECT
CLEANING FLUID discussed above).
- 37 -
Publicidad
