Publicidad
Idiomas disponibles
Idiomas disponibles
Installation
1. Take the beer cooler out of its packaging. Place it on a steady, horizontal surface, and make sure it
is at least 10 cm away from other appliances or the wall on each side, so as to allow correct ventilation
of the appliance and ensure a better performance.
2. Install the tap handle by connecting it to the tap, making sure both ends fit together perfectly.
3. Lift the main machine backwards at an angle of 10-15°. Align the drip tray with the slot at the bottom
of the main machine, insert and assemble the drip tray, and then place the product flat on the worktop.
4. Plug in the beer cooler.
Note: Do not connect or disconnect the plug while your hands are wet. Before use, make sure the
voltage conforms with the mark on the plug, and check that the power cord is well connected; if not,
please refrain from use and call the service centre.
Heineken Keg
Heineken kegs are pre-loaded with Co2, and do not require the use of a regulator. There is no need to
install a Co2 unit.
1. The Heineken connector that comes with your beer cooler can work with all Heineken 5-litre kegs.
However you must use the flat headed screwdriver provided with the beer cooler to remove the green
base from the keg and install the new connector.
2. Install the adapter of the beer cooler according to the method on the keg description.
46
Publicidad
