Hisense HBD5A Manual De Instrucciones página 53

How to change the beer tube
If the beer tube breaks, leading to a leakage, make sure to replace it immediately.
1. Open the detachable tap cover, pull the tap handle in the direction of the beer, and pull out the
beer tube.
2. For a Heineken keg: remove the beer throat clip and pull out the Heineken adaptor.
3. For a universal 5L keg: remove the beer throat clip and pull out the quick connector.
4. Get a new beer tube and install it in reverse order.
Switch button and remove
tap on the top cover
Troubleshooting
Problem
The tap does not work /
beer is not coming out.
Too much foam coming
out
Beer flows out too
slowly.
ENVIRONMENT
At the end of the appliance's usable life, do not discard it with common household waste. Take it to an
authorised recycling centre; this will help preserve the environment.
Throat clip
Heineken
adaptor
Possible cause
1. The pouring tube is not
properly connected.
2. No keg, or no beer in the
keg.
1. The beer is not being poured
correctly.
2. The temperature of the beer
is too high (best at 3-6°C).
3. The keg was shaken before
use.
4. There is almost no beer left
in the keg.
1. Co2 pressure inside the keg
isn't high enough.
2. The connection tube or
pouring tube is leaking.
Solution
1. Make sure the pouring tube is well
connected.
2. Change to a new keg.
1. Use the correct method to pour the
beer.
2. Cool the beer down to 3-6°C.
3. Put the beer keg aside for a while
until there is no foam remaining
inside.
4. Change to a new keg.
1. Change to a new keg.
2. Check whether the tube is leaking;
if so, replace the tube.
52
Switch button and remove
tap on the top cover
Throat clip
Quick connector