UFESA PAC Alaska 7 Manual De Instrucciones página 50

a handle. Never attempt to turn off the appliance by disconnecting the plug. To avoid
risk of fire or explosion, do not spray anything onto the appliance. Do not put any in-
flammables or chemicals near the unit. To prevent plastic parts from melting or catching
on fire, do not place the appliance near heating appliances. Moving and hot parts: Do
not operate unit with back cover removed. The appliance must be used on a level and
stable surface. Do not use outdoors. Be careful that a heating appliance is not exposed
to the wind from the appliance. Do not cover the unit with washed clothes or similar
items. Unplug the product immediately from the mains in the event of any breakdown
or damage and contact an official technical support service. In order to prevent any risk
of danger, do not open the device. Only qualified technical personnel from the brand´s
Official technical support service may carry out repairs or procedures on the device.
B&B TRENDS SL. disclaims all liability for damages that may occur to people, animals or
objects, for the non-observance of these warnings.
BEFORE INITIATION
Be sure to remove any packing material from the inside of the appliance.
To avoid damage, place the unit in an upright position for at least 24hours before initial
start.
Make sure that the air outlet and air inlet are never blocked.
Only operate the unit on a horizontal surface to ensure no water leaks out.
INSTALLATION
A) Location and installation of the accessories
• The portable air conditioner must be placed beside a window or a door.
• To avoid over-heating of your appliance, a minimum distance of 60cm must be kept
between the back of the appliance and the wall, or any bulky object.
Advice for water drainage set-up
Water is produced during cooling and dehumidifying. Therefore, you need to set up a
drainage system. You can either choose to set up an automatic (continuous) drainage
system or drain the water manually.
1. Automatic Drainage
Water drainage is continuous if you use the upper drainage port (secondary drainage
port) with a drainage pipe. For instructions on set-up, please refer to MAINTENANCE
AND CLEANING.
2. Manual Drainage
Water fills up an internal recycling tank during operation, and when the tank is full, the
alarm will sound and the compressor will stop working, indicating that the water tank
should be emptied.
For how to manually empty water from the tank to resume operation, please refer to
MAINTENANCE AND CLEANING.
B) Installation of the air exhaust hose and the window adapter
1. Extend the air exhaust duct by pulling out the two ends of the duct.
50