Publicidad
Idiomas disponibles
Idiomas disponibles
Air valve
11 - Connect machine, open electrode holder air compressed valve. The machine is ready to work.
12 – To allow arc ignition, make electrode contact with workpiece, respecting the recommended angles.
2.3 – Error messages:
During machine running, several error messages can be showed at the digital display:
Er 1 – This message indicates that machine is automatically stopped by thermal surcharge due to exceeding of duty cycle.
Machine must be stopped until cool down and automatically reset.
ady to work.
Er 2 – This message indicates that machine is automatically stopped due to failure of the torch cooling fluid. Check:
- regular functioning of fluid cooler.
- level fluid of cooler tank.
- twists and bottlenecks of torch cooling tubes.
Er 3 – This message indicates that the torch trigger is accidentally activated when machine is switched on.
Er 4 – This message indicates failures of communication between frontal PCBoard (in the wire feeder) and interface PCBoard (in
the machine). Electrical contacts failures must be checked out. If necessary, PCBoards must be changed.
3 – TECHNICAL DATA
MIG 300M
Tecnical data
Current adjustment
Wire diameters
Weight
Dimensions
No-load voltage board
Pos.
2
3
4
5
1
Volt
16.5 18.5 20.5 22.5 24.0 26.0
12
Cutting recommended angle
Mig 300M
12 (1x12) positions
Ø 0.6 – 1.0 mm
78 Kg
134 x 41 x 96 cm
6
7
8
9
10
11
12
28.0
30.0 32.0 34.0 36.0
38.0
300M / 350M / 400M / 450M / 500M / 650M
70/80º
MIG 350M
Tecnical data
Current adjustment
Wire diameters
Weight
Dimensions
No-load voltage board
Pos.
1
2
A
17.0
18.7
B
17.4
19.3
C
17.7
19.7
D
18.1
20.1
35º
Gouging recommended angle
Mig 350M
28 (7 x 4) positions
Ø 0.6 - 1.2 mm
122 Kg
134 x 41 x 96 cm
3
4
5
6
7
20.7
22.7
25.8
29.4
33.7
21.3
23.3
27.0
30.7
35.1
21.9
24.0
27.7
32.1
36.5
22.3
24.6
28.4
32.8
38.0
Publicidad
