Descargar Imprimir esta página

Numatic HNS1550 Traducción Del Manual De Uso Original página 15

Publicidad

EN
READ MANUAL BEFORE USE
COMPONENT
Mains Lead
Pads/Brushes
Handle and Deck
Operators shall be adequately instructed on the use of this machine.
This machine shall be disconnected from its power source (Remove plug from socket outlet.) During cleaning or
maintenance or in the event of an accident and when replacing parts or converting the machine to another function.
This machine is not suitable for picking up hazardous dust.
WARNING
Do not allow supply cord to come into contact with the rotating brushes or pads
As with all electrical equipment care and attention must be exercised at all times during its use, in addition to ensuring that routine and preventive
maintenance is carried out periodically in order to ensure its safe operation. Failure to carry out maintenance as necessary, including the
replacement of parts to the correct standard could render the equipment unsafe and the manufacturer can accept no responsibility or liability in this respect.
When ordering spare parts always quote the model number / serial number specifi ed on the rating plate.
This machine is for indoor use only.
The machine is not to be used or stored outdoors or in wet conditions.
Don't allow the machine to be used by inexperienced or unauthorised operators or without appropriate training.
Only use brush provided with the appliance or those specifi ed in the instruction manual.
The use of other brushes may impair safety.
A full range of brushes and accessories are available for this product.
Only use brushes or pads which are suitable for the correct operation of the machine for the specifi c task being
preformed.
It is essential that this equipment is correctly assembled and operated in accordance with current safety regulations. When using the equipment always ensure that all
necessary precautions are taken to guarantee the safety of the operator and any other persons who may be aff ected.
This machine is not suitable for picking-up hazardous dust.
Do not use on surfaces having a gradient exceeding that marked on the appliance.
The machine is not to be stored outdoors in wet conditions.
This machine is for indoor use only.
Read the instruction manual before using the appliance.
This product meets the requirements of IEC 60335-2-67
Read the instruction manual before using the appliance
NOTE:
This Product meets the requirements of BS EN 60335 - 2-67
This Machine is also suitable for commercial use, for example in hotels, schools, hospitals, factories, shops,
rental businesses and offi ces for other the normal housekeeping purposes.
CAUTION
Care should be taken in the choice of chemicals, detergents and other liquids. Consult your supplier.
NOTE: This machine is intended for commercial use, for example in hotels, schools, hospitals, factories, shops, offi ces and rental
businesses.
• Ensure only competent persons unpack/ assemble the machine.
• Keep your machine clean.
• Keep your brushes in good condition.
• Replace any worn or damaged parts immediately.
• Daily examine the mains lead for damage, such as cracking or aging. If damag is found, replace the lead before further use.
DO
• Only replace the mains lead with the correct Numatic approved replacement part.
• Ensure that the work area is clear of obstructions and / or people.
• Ensure that the working area is well illuminated.
• Pre - sweep the area to be cleaned.
• Use steam cleaners or pressure washers to clean the machine or use in the rain.
• Attempt machine maintenance or cleaning unless the power plug has been removed from the supply outlet.
• Allow any inexperienced repairs. Contact your nearest service centre.
• Strain the mains lead or try to unplug by pulling on the mains lead.
• Leave the brush deck in the lowered position when not in use.
• Expect the machine to provide trouble free, reliable operation unless maintained correctly.
DON'T
• Run the machine over any power cables during operation.
• Leave your machine standing on brush, pads or drive boards when not in use.
Information for Floor Machine
INTERVAL
DAILY
BEFORE EACH USE
BEFORE EACH USE
Scuffi ng, cracks, splits, conductors showing
Damage, wear, drive collar wear
15
15
INSPECT FOR
Wear, cracks, splits

Publicidad

loading