Operation
Switch on your hob
The controls respond to touch, so there is no need to apply any pressure.
•
Use your fingertip, not the tip.
•
You will hear a beep each time a touch is registered.
•
Make sure that the controls are always clean, dry and that no object (e.g.
utensil or cloth) is covering them. Even a thin layer of water can hinder the
operation of the controls..
Tips to avoid property damage
ATTENTION! Containers with rough bases may scratch the hob.
•
Check that all pans are in perfect condition. Cooking under vacuum can damage the pans and even
the hob. Never place empty pans on a hot cooking zone or allow them to heat up empty.
•
Improperly positioned pans on the hob can cause the hob to overheat..
•
Do not place hot pots and pans on the controls or the hob frame.
•
Dropping rigid or sharp objects on the hob can cause damage.
•
Non-heat-resistant materials may melt if they are placed on the hob when it is in operation or has
just been used.
•
Never use aluminium foil, plastic containers or baking paper.
•
Use pans with a diameter as large as the graphic of the selected zone. If you use a pan that is slightly
wider, the energy will be used to the maximum. If you use a pan smaller than the selected zone, the
efficiency may be lower than expected. Always centre the pan on the cooking zone.
Always lift the pans from the hob, do not slide them, as this could scratch the glass.
Locking the controls
You can lock the controls to prevent unintended use (e.g. children accidentally switching on the cooking
zones).
To lock the controls:
Touch the lock control for 3 seconds. The timer indicator will show "Lo".
To unlock the controls:
1. Make sure that the glass ceramic hob is switched on.
2. Touch the key lock control and hold it down for 3 seconds.
3. You can now start using your glass ceramic hob.
Note: When the hob is locked, all controls are disabled except the ON/OFF button. You can always switch
off the hob with the ON/OFF control in an emergency, but you must unlock the hob first.
38
English
infiniton.es