YATO YT-828133 Instrucciones Originales página 16

PRODUCT OVERVIEW
The power saw is only intended for cutting wood. The power saw electric drive allows it to be used under a canopy or near build-
ings. Thanks to the battery power supply, the power saw allows you to work in places where mains-powered products could not be
used. The power saw is used to cut branches, and trim shrubs and bushes. The power saw is not designed to fell trees. Proper,
reliable and safe operation of the tool depends on appropriate use, that is why you should:
Read the entire instructions manual before the fi rst use of the tool and keep it for future reference.
The supplier shall not be held liable for any damage or injury resulting from improper use of the tool and failure to observe the
safety regulations and recommendations specifi ed in this manual. Use of the tool for purposes other than those for which it was
intended shall cause the loss of the user's rights to a warranty and statutory warranty.
PRODUCT EQUIPMENT
The power saw is supplied complete but requires assembly before fi rst use. The following elements are supplied with the power
saw: a chain guide bar, a cutting chain and a guard for the guide bar with chain. The battery and charging station (charger) are
only provided with the YT-828133 product. The YT-828134 product does not come with a battery and charger.
TECHNICAL DATA
Parameter
Catalogue No.
Rated voltage
Chain speed
Guide bar length
Chain pitch
Guide slot width
Weight (without the battery, guide bar and chain)
Noise level
- LpA (pressure)
- LwA (power)
Vibration ah
Battery type
Battery capacity*
Charging station*
Input voltage
Mains frequency
Rated current
Output voltage
Output current
Charging time**
* only for models equipped with a battery and charger
** the specifi ed charging time applies only to the battery with the capacity listed in the table
The declared noise emission value has been measured using the standard test method and can be used to compare one tool to
another. The declared noise emission value can be used in the preliminary exposure assessment.
The declared total vibration value has been measured using the standard test method and can be used to compare one tool to
another. The declared total vibration value can be used in the initial exposure assessment.
Note! The vibration emission during tool operation may diff er from the declared value, depending on the manner the tool is used.
Note! Safety measures to protect the operator, which are based on an assessment of exposure under actual conditions of use (in-
cluding all parts of the work cycle, such as the time when the tool is switched off or idle and the activation time), must be specifi ed.
GENERAL WARNINGS FOR THE SAFETY OF POWER TOOLS
Warning! Read all safety warnings, illustrations and specifi cations provided with this power tool. Failure to do so may
result in electric shock, fi re or serious injury.
O R I G I N A L
16
EN
Unit
[V]
[m/s]
[mm / '']
[mm]
[mm / '']
[kg]
[dB] (A)
[dB] (A)
[m/s ]
2
[Ah]
[V]
[Hz]
[A]
[V]
[A]
[h]
I N S T R U C T I O N S
Value
YT-828133, YT828134
18 DC
8
176 / 7
7,62
1,1 / 0,043
1,58
78 ± 3,0
95,0 ± 3,0
1,4 ± 0,5
Li-Ion
2
200 – 240 ~
50 / 60
1.5
21.5 DC
2.2
1