SEVERIN PG 1511 Instrucciones De Uso página 15

suffi cient time to cool down before
carrying, transporting or storing it. Pour
out any remaining water after use.
∙ Ensure that the grill is not stored
outdoors, or in any other location where
it might be subjected to extremes of
temperature or high humidity.
∙ No responsibility is accepted if damage
results from improper use, or if these
instructions are not complied with.
∙ This product complies with all binding CE
labelling directives.
Grill assembly
The barbecue grills are available in different
confi gurations.
When assembling the grill, always refer to
diagram A corresponding to your particular
grill model. Follow the steps below:
∙ Place the grill pan inside the plastic
housing.
∙ Place the heating element into the grill
pan.
∙ Fit the grill rack on top.
∙ If required, additional accessories may
be fi tted according to diagram A for your
particular grill model.
Grill models with additional base stand:
Assemble the base stand according to the
schematic diagram B. Place the grill onto the
stand in such a way that the small feet under
the grill connect in the top of the vertical legs
of the base stand; ensure that the grill and
base stand are placed in a safe and stable
position.
The power cord should be routed in such a
way that no one is likely to trip over it.
Heating element
The junction box contains a safety switch.
Place the grill pan into the plastic housing
fi rst, and then fi t the heating element inside
the grill pan and housing. The safety switch
is activated automatically when the heating
element has been properly fi tted. If not fi tted
correctly, the appliance cannot be switched
on.
Before using for the fi rst time
∙ Remove any packaging materials from
the appliance.
∙ Clean the grill rack and grill pan with
warm soapy water; dry thoroughly
afterwards.
∙ Assemble the grill as described above.
∙ Fill the grill pan with water up to the 'Max'
marking.
∙ Insert the plug into a suitable earthed
power-outlet.
∙ Let the grill heat up for approximately 5
minutes without any food on the rack. This
will lessen the smell typically encountered
when fi rst switching on a new grill (a slight
smell and a little smoke may be emitted -
ensure suffi cient ventilation).
∙ For grill models with a thermostat control,
let the grill heat up with the control knob
set to its 'MAX' position.
Grilling
∙ The grill pan must be fi lled with water up
to the 'Max' marking.
∙ Grill models without thermostat control:
Insert the plug into a suitable earthed
power-outlet.
∙ Grill models with thermostat control:
Insert the plug into a suitable earthed
power-outlet. Set the thermostat control
knob to its 'Max' position. The indicator
15