Preparation Of Top Cabinet - Haier HM1630 Manual Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

B3. ATTACH THE MOUNTING PLATE TO THE WALL
Attach the plate to the wall using toggle
bolts. At least one wood screw must be
used to attach the plate to a wall stud.
1.
Remove the toggle wings from the bolts.
2.
Insert the bolts into the mounting plate
through the holes designated to go into
drywall and reattach the toggle wings to
3⁄4" (19 mm) onto each bolt.
TO USE TOGGLE BOLTS:
3.
Place the mounting plate against the
wall and insert the toggle wings into the
holes in the wall to mount the plate.
NOTE: Before tightening toggle bolts and wood screw,
make sure the tabs on the mounting plate touch the
bottom of the cabinet when pushed flush against the wall
and that the plate is properly centered under the cabinet.
CAUTION: Be careful to avoid pinching fingers
between the back of the mounting plate and thewall.
4.
Tighten all bolts. Pull the plate away
from the wall to help tighten the bolts.
B4. USE TOP CABINET TEMPLATE FOR PREPARATION OF
TOP CABINET
You need to drill holes for the top support
screws, a hole large enough for the power
cord to fit through.
Read the instructions on the TOP
CABINET TEMPLATE.
Tape it underneath the top cabinet.
Drill the holes, following the instructions
on the TOP CABINET TEMPLATE.
Wear safety goggles when drilling holes in the cabinet bottom.
Mounting
Plate
CAUTION:
Spacing for Toggles
More Than Wall
Thickness
Toggle Wings
Toggle
Bolt
Wall
Bolt End
English
English
18

Publicidad

Tabla de contenido
loading

Tabla de contenido