Preparation; Power Sources; Using A Aaa Battery; Power Supply Status Indicator - Tascam DR-10X Manual Del Usuario

Preparation

Power sources

This unit can operate on one AAA battery or USB bus
power using the included USB cable.
This unit can use an alkaline, Ni-MH or lithium AAA
battery.

Using a AAA battery

Open the battery compartment cover on the back
of the unit. Install 1 AAA battery in the compartment
with the ¥ and ^ marks as shown. Then, close the
battery compartment cover.
When using a AAA battery, set the type of battery
in order to accurately show the amount of power
remaining and allow the unit to accurately determine
whether power is available for proper operation. (See
"Making menu settings" on page 15.)
CAUTION
• AAA manganese dry cell batteries cannot be
used with this unit.
• This unit cannot recharge AAA Ni-MH batteries.
Use a commercially-available recharger.

Power supply status indicator

When operating on battery power, a battery icon
appears at the top right of the display.
The battery icon shows the amount of power
remaining in bars ( q q ).
The battery is almost dead and the power will soon
turn off if the icon with no bars blinks. When
operating on USB bus power, the icon appears.
Connecting with a
microphone
Connect the XLR connector to the microphone.
NOTE
• Turn the clamp nut in the opposite direction
of CLAMP> and then attach the mic to the
connector.
• If the connection is loose between this recorder
and the mic, turn the clamp nut in the direction
of the arrow to secure it.
• Do not hold the DR-10X when it is connected to
a mic. (Hold the mic.)
Clamp nut

Turning the unit on and off

CAUTION
Do not wear connected headphones when
turning the unit on and off. A loud noise could
damage to the speakers or harm your ears.

Turning the unit on

When the unit is off, slide the ¤?o — 0REC
switch toward ¤ and hold it for about one second
until the startup screen appears
TASCAM DR- 10
and the unit starts.
The Home Screen shown below appears after the
unit starts up.
NOTE
If the unit is not used for a few minutes, the
display will appear as below in screensaver
mode.
TASCAM DR-10X
11