Troubleshooting - LD Systems LDMEI1000G2 Manual De Usuario

SETUP
For optimal transmission, position the transmitter at a minimum height of 1 m and point the antenna
upwards. If multiple wireless systems are used in an installation, please make sure
that the antennas do not touch or cross. Do not position the transmitter in the direct vicinity
of metal objects and digitally controlled devices (CD players, computers, digital consoles, etc.). Transmitter and
receiver should be within direct "line of sight" of each other.

TROUBLESHOOTING

PROBLEM
Receiver: Display is switched off.
Transmitter: Display is switched
No sound or volume Receiver: is on, but the RF indica-
too low.
Receiver: is on and the RF indica-
Distortion or noise.
Receiver: LOW BATT LED lights up
Distorted sound.
SETTING UP AND TROUBLEShOOTING:
DISPLAY
off.
tor is not lit.
tor is lit.
Receiver: RF indicator is on.
Transmitter: Level indicator is
too high
SOLUTION
Make certain that the batteries are not dead
and the receiver is on.
Check the connection between power supply
and transmitter. Turn on the transmitter.
Make certain that the transmitter and receiver
are set to the same radio frequency.
Reduce the distance between transmitter
and receiver and make certain that there
is a direct line of sight between transmitter
and receiver.
Make certain that the transmitter antenna is
installed correctly.
Increase the volume at the receiver and
check the headphone connection.
Check the input level on the transmitter and
increase it if necessary.
Increase the distance to possible causes of
interference (digitally controlled devices, e.g.,
CD players, computers, digital consoles...).
Use a different radio frequency.
Replace the batteries with new ones.
Lower the volume at the level controls of
the transmitter or at the source device.
15