Charging Battery Pack - Skil 2230 Instrucciones De Funcionamiento Y Seguridad

SM 1619X04086 04-09:SM 1619X04086 04-09 5/5/09 9:40 AM Page 10
ADJUSTABLE CLUTCH
Your tool features 16 clutch settings. Output
torque will increase as the clutch ring, is rotated
from 1 to 15. The drill "
up the clutch to permit drilling and driving for
heavyduty work (Fig. 1).
When the trigger switch is released it activates
the brake to stop the chuck quickly. This is
especially useful in the repetitive driving and
removal of screws.
Plug charger cord into your standard power
outlet. Before inserting battery pack, remove
protective cap, then insert battery pack into
charger (Fig. 3).
The charger's green light (Fig. 3), will turn
"ON". The green light remains ''ON'' as long as
charger is plugged in, and does not shut off.
After normal usage, the battery pack requires
approximately 3-5 hours or less charging
time to become fully charged. If the battery
pack is run-down completely, it may require
INDIC TOR
LIGHT
" position will lock
BRAKE

CHARGING BATTERY PACK

CH RGER
RELEASING AND INSERTING
BATTERY PACK
Release battery pack from tool by pressing on
both sides of the battery release tabs and pull
downwards. Before inserting battery pack,
remove protective cap from battery pack. To
insert battery, align battery and slide battery
pack into tool until it locks into position. Do
not force.
up to 5 hours charging time to become fully
charged.
When the battery pack is fully charged,
unplug the charger (unless you're charging
another battery pack) and slip the battery
pack back into the tool handle.
To prevent fire or injury
W RNING
when batteries are not in
tool or charger, always place protective
cap onto end of battery pack. Protective
cap, guards against terminal shorting.
FIG. 3
B TTERY
P CK
PROTECTIVE
C P
-10-