SEVERIN AH 7913 Instrucciones De Uso página 11

∙ If the vacuum cleaner is not being used
for a long period of time, the capacity of
the battery may decrease by a certain
amount. However, full capacity will be
restored after several charge/discharge
cycles.
12 V operation
∙ With the 12 V connector, the battery
pack may be recharged through the car
cigarette-lighter socket.
∙ Insert the small plug of the connecting
cable into the 12V jack of the vacuum
cleaner, and the larger plug into the car's
cigarette-lighter socket.
∙ Power is now supplied directly from the
car's electrical system; the indicator lamp
shows red.
Picking up liquid matter
Before picking up liquid matter, ensure that
the rubber nozzle is fully inserted in the
suction aperture.
Crevice tool
The crevice tool can be inserted into the
suction aperture to clean crevices, corners
and other areas diffi cult to reach.
Crevice brush
The crevice brush can be fi tted to the crevice
tool and is suitable for cleaning uneven
surfaces such as computer keyboards etc.
Operation
∙ Remove the vacuum cleaner from its wall
bracket.
∙ If required, fi t any of the nozzle
attachments to the suction aperture.
∙ Switch on the appliance using the On/Off
switch. The indicator lamp shows green.
∙ Always ensure that the dust container is
emptied in good time, before the dust or
liquid matter collected reaches the level of
the inner suction tube (see max marking).
∙ If the battery loses power during
operation, the green indicator lamp starts
fl ashing and the appliance switches off
after a while; this is to prevent excessive
discharge of the battery pack. In this
case, the battery pack needs recharging.
Always ensure that the appliance is
switched off before putting it in the
charging station.
Cleaning and care
General
∙ Before cleaning the appliance, remove
the vacuum cleaner from the wall bracket.
∙ To avoid the risk of electric shock, do not
clean the appliance or the adaptor with
liquids and do not immerse them.
∙ If necessary, the housing may be wiped
with a damp cloth. Wipe dry afterwards.
To empty the dust container
Reduced vacuuming power despite a fully
charged battery pack indicates that the dust
container and fi lter inlay must be emptied.
∙ Hold the vacuum cleaner with the dust
container facing downwards.
∙ Push the release button, open the dust
container in a downward and forward
direction, remove the fi lter and empty it.
∙ The fi lter may be cleaned by slightly
tapping it, or by gentle brushing. The
fi lter can be separated from its holder by
simply turning fi lter and holder in opposite
directions and taking the fi lter off.
∙ Should the fi lter be visibly dirty, it should
be thoroughly cleaned with soapy
water; make sure to let it dry completely
11