Bio Bronpi Radiofrecuencia Serie Instrucciones De Instalación, Uso Y Mantenimiento página 43

Idiomas disponibles

9.5

USER MODE

Below is a description of the control normal operation according to the available

functions.

Before the ignition of the stove or insert, the control shows the following screen (see

drawing D85): It is showed up the "off" state, the room temperature, the established

working power and the current hour.

9.5.1

STOVE OR INSERT IGNITION

In order to ignite the stove, press button no. 3 during a few seconds. The control will

show the ignition state as follows (see drawing D86):

The maximum length of the ignition phase is 20 minutes. After this time, if there is no

visible flame, the stove will automatically go into the alarm state and the control will

show the message "Ignition Failure."

9.5.2

STOVE OR INSERT IN OPERATION

The hot air fan will start when the smoke temperature reaches a minimum. Auxiliary fans

(in case of models of channelling stoves Agatha Extra, Alicia Extra, Clara Extra, Cleo

Extra and Olivia Extra) will start only if enabled.

In this moment, the stove or insert is correctly burning. After this, our stove will be

working normally (see drawing D87).

The control shows the ambient temperature in the room.

9.5.3

CHANGE OF THE SET-POINT ROOM TEMPERATURE

In order to modify the setting room temperature, please press button 4 and then buttons

1 and 2 to increase or decrease it respectively (see drawing D88).

9.5.4

ROOM TEMPERATURE REACHES TEMPERATURE FIXED BY THE USER

When the ambient temperature (of the room) reaches the value set by the user or the

smoke temperature reaches a too high value, the stove or insert will automatically

operate at one lower power, it means that modulates in power. See drawing D89.

Remember that if it is activated "stand-by mode", when the ambient temperature

reaches the value set by the user plus a differential (2ºC) the stove or insert will be

automatically turned off and will be on hold until the ambient temperature falls to

the set temperature minus a differential (2ºC). After that, the stove or insert restarts

automatically.

9.5.5

BURNER CLEANING

While the stove or insert is working normally, some automatic cleanings of the burner

take place in several minutes intervals. This process consists of cleaning the rest of

pellet remaining in the burner in order to guarantee a proper working of the stove or

insert (see drawing D90) and it takes several seconds.

9.5.6

TURNING OFF THE STOVE OR INSERT

In order to turn off the stove or insert, press button no.3 during a few seconds. Once it

has been turned off, it will start the final cleaning stage, in which the pellet supply stops

and the smoke extractor will be working to the maximum speed. This stage would not

finish until the stove or insert has reached the appropriate cooling temperature (see

drawing D91).

9.5.7

STOVE OR INSERT TURNED OFF

When the stove is turned off, the control shows the following information (see drawing

D92):

9.5.8

RE-IGNITION OF THE STOVE OR INSERT

When the stove or insert is turned off it would not be possible to restart it up until some safety time goes by and the

stove or insert is cold enough. If you try to start-up the stove, the display will show up the following information (see

drawing D93):

10 ALARMS

In case of an anomaly during the operation, the electronics of the stove or insert intervenes and highlights the

irregularities that have ocurred in the different working phases, depending on the type of fault.

Every alarm situation blocks the stove or inserts to be automatically blocked. By pressing button 3 we can unblock

it. Once the stove or insert has reached the appropriate cooling temperature, the user can restart it up.

INSTALLATION, OPERATING AND SERVICING INSTRUCTIONS