General Characteristics Of The Operator; Main Operator Parts - Erreka MAGIC Manual Del Instalador

DESCRIPTION OF THE PRODUCT
2

GENERAL CHARACTERISTICS OF THE OPERATOR

The MAGIC operator is made to form part of an
automated system, integrated in the frame of iron or
aluminium swing doors.
It comprises a metal body, which contains the motor
and a planetary gearbox.
The MAGIC operator allows opening of 180º.
This operator, along with its corresponding Erreka
control board, allow the implementation of a gentle
halt system, with the speed slowing down at the end of
the closing and opening operations.
3

MAIN OPERATOR PARTS

Fig. 2 Main parts
44
Installation Manual
The MA210 and MA250 models are reversible,
meaning the installation must be fitted with an
electrolock.
The MA210F/MAS210F and MA250F/MAS250F are
fitted with a brake. An electrolock is only required for
leaf lengths of over 1.8 m.
The MAS210F and MAS250F models, apart from a
brake, are fitted with an encoder.
Components
1 Base plate with pin
2 Bottom mount
3 Countersunk M6 screws (8)
4 Adaptation plate (for iron
profile)
5 Operator (MA210F/MAS210F)
6 Countersunk M10 screws (4)
7 Bushing seal
8 Top mount with joint
9 Nuts M8 (2)
10 Angle
11 Upper pin unit
12 Glands
13 Screws M8 (2)
14 Pressure washer M8 (2)
15 Water guard
Wiring
• Grey wire: motor (common)
• Brown wire: motor (turning 1)
• Black wire: motor (turning 2)
• Yellow/green wire: earth
• Orange wire:
no encoder: not included
with encoder: brake
• Purple wire:
no encoder: not included
with encoder: brake
• Blue wire:
no encoder: not included
with encoder: encoder signal
• White wire:
no encoder: brake
with encoder: common (–) of
the encoder
• Red wire:
no encoder: brake
with encoder: power supply
D249A
(+) of the encoder