Setting The Clock - Kalorik USK CCG 2 Manual De Instrucciones

BEFORE FIRST USE
When you use your appliance for the first time, pour fresh water
•
into the water tank (without coffee), press the "BREW" button and
switch on the appliance.
Once all the water has passed through, switch off the appliance
•
and let it cool down. When it is cold enough repeat the process 3
times with fresh water.

SETTING THE CLOCK

Plug in your coffee maker. The time "12:00" will be displayed on
•
the electronic digital clock.
To set the current time, press the Time Set button. The first digit of
•
the hours will start flashing. Adjust the hour by pressing the "▲"
button. After a few seconds, the digit will stop flashing. Repeat
the operation for the 2
PROGRAMMING THE COFFEE MAKER
Your coffee maker has a 24 hours timing, but the programmed clock
remains in the memory as long as you do not modify it.
Check the time displayed on the clock.
•
Open the lid of the water tank (the smallest lid on top of the
•
appliance) and fill it with water. The number of cups can be read
on the graduated water tank. Close the lid.
Pull the filter holder out using its handle, fill the permanent filter
•
with the desired quantity of ground coffee or use the grinder (see
"USING THE COFFEE GRINDER" section). Then replace the filter
holder in its initial position.
Set the desired programming time by pressing the delay set
•
button. You can then adjust the time you want your appliance to
start by doing the same as described for the setting of the clock.
After both clock time and delay time have been set, you can
•
press the ▲ button to check the delay time when your appliance
will start.
nd , 3 rd and 4 th digit of the clock.
5
USK CCG 2 - 071214