Zippie YOUNGSTER 3 Manual De Usuario página 10

transportability >>>
occupant restraints Instruction:
1. The pelvic restraint belt must be worn low across the front
of the pelvis so that the angle of the pelvic belt is within the
preferred zone of 30 to 75 degrees to the horizontal.
A steeper (greater) angle within the preferred zone is
desirable i.e. closer to, but never exceeding 75 degrees. (Fig
C)
2. The upper torso restraint belt must fit over the shoulder
and across the chest as illustrated Fig d and e
Restraint belts must be adjusted as tightly as possible
consistent with user comfort.
Restraint belt webbing must not be twisted when in use.
The upper torso restraint belt must fit over the shoulder and
across the shoulder as illustrated in Fig D and E.
3. The attachment points to the chair are the inner front side
frame just above the castor, and the rear side frame. The
straps are fitted around the side frames at the intersection of
the horizontal and vertical frame tubes. (See Figs G-H-I)
4. The tie down symbol (Fig F) on the wheelchair frame
indicates the position of the wheelchair restraint straps. The
straps are then tensioned after the front straps have been
fitted to secure the wheelchair.
fig.c
prefered
fig.d
fig.e
fig.f
10
YOUNGSTER 3
zone
transportability – positioning of wheelchair tie down
restraints on wheelchair
The wheelchair secured with front and rear wheelchair tie
down restraints, (Fig.K).
Position of the front wheelchair tie down restraint and the
tie down position, (Fig.I).
Position of the rear wheelchair tie down restraint and the
tie down position on the wheelchair, (Fig.J).
fig. g
fig. h
fig. I
fig. J
fig.k