Polaris TR36P Manual De Instrucciones página 6

3
Test Water Pressure
1. Turn on the filtration pump.
2. With the hose connected to the UWF
the pressure tester (o) under water. Cover the
large hole with your thumb and confirm water is
releasing from the pressure
relief valve (i).
NOTE: There are two holes in the end of the pressure
tester. It is important to block the larger hole to verify
pressure.
No water flow from pressure relief valve?
• If your Polaris
increase the water flow to the cleaner.
• Make sure filter screen (k) is correctly positioned in Quick Disconnect.
• Check skimmer, pump basket, and main filter for debris restricting flow.
• If the Polaris cleaner is connected to one of multiple return lines, verify you have the correct
4
Polaris return line connection kits installed (see page 5 of this manual).
Adjust Hose Length
1. Turn the pump on. Hold hose
under water until the pressure
relief valve releases pressure.
2. Extend the hose to the
farthest point of the pool.
The hose end must be within
6 inches (15 cm), longer or
shorter.
3. Measure the hose with the
pressure on and cut excess
length from the first hose
section (p). (This is the
section connected to the
Quick Disconnect (i).)
4. Reconnect hose sections.
5. After adjusting the hose
length, position the three
hose floats as shown.
Hose too short?
• Contact your local Polaris dealer. Buy a new hose section. Add to
the first hose section (p) and cut until within 6 inches (15 cm).
6
, hold
®
®
cleaner is connected to a dedicated cleaner line, adjust the diverter valve to
7ft (2.13m)
o
4ft (1.2m)
Float (g)
Flotteur (g)
Flotador (g)
f
p
i
i
6 in (15cm)
h
g
Recommended
Recommandé
Recomendado